論文・報告
No. | タイトル・執筆者 |
---|---|
7 |
|
CO2排出量削減に関する取り組みとして、産業副産物由来の混和材を大量に使用したコンクリートが提案されている中、筆者らは、混和材だけでなく細骨材にも産業副産物を使用した圧縮強度の特性値が50MPa程度の低収縮かつ低発熱コンクリートを開発し、初期の強度発現に与える温度の影響などを実験的に検討してきた。本稿では開発した低収縮かつ低発熱コンクリートを橋梁上部工のPCa下床版間詰部へ適用した事例について報告する。コンクリートの製造は、事前に水と化学混和剤を除くその他の材料をフレキシブルコンテナバッグに計量したプレパック材を製作し、現地に設置した移動式プラントにより行った。また、施工は一般的なコンクリートと同様にバイブレータによる締固めを行い、冬期施工時には10℃程度に加温した水を練混ぜ水として使用し、コンクリートの練上がり温度を極端に低温とさせないような対策を行った。その結果、品質の安定した低収縮かつ低発熱コンクリートを製造し、施工することができた。 キーワード : 混和材、低収縮、低発熱、現地製造 |
|
|
|
In efforts to reduce CO2 emissions, concrete that includes large amounts of admixtures made with industrial by-products has been proposed. In this context, the authors have developed a low-shrinkage and low-heat concrete with a characteristic compressive strength of about 50MPa by using industrial by-products not only as admixtures but also as fine aggregates. The effects of temperature on early strength development of this concrete are already established. This paper reports its application to construct the lower deck joints of a concrete box girder bridge. The concrete row materials, except for water and chemical admixtures, were pre-packed in flexible bags. The pre-packed materials were processed to make concrete using a mobile plant installed on-site. The construction was carried out similarly to standard concrete, with compaction done using vibrators. During winter construction, water was heated to approximately 10°C before mixing to keep concrete at an appropriate temperature. As a result, it was possible to manufacture good quality low-shrinkage, low-heat concrete on site and successfully finish the construction. Key Words : Supplementary cementitious materials, Low shrinkage, Low heat, On-site production |